Experience the thrill of off-road adventures like never before with the Ausom Gallop! Its intelligent LCD dashboard allows for a clear display of real-time data and smart control of your electric scooter.

 

Displayed Contents

 Ausom Gallop Electric Scooter Display Screen

Functions & Operations

Power on/off: To turn on the scooter, insert the key into the keyhole and turn the key clockwise. Press the power switch for 3 seconds to turn on the scooter. To turn off the scooter, press the function switch button for 3 seconds and turn the key counterclockwise.

Shifting Speed Level: When the power is turned on, short press the function switch button to shift among 3-speed levels.

Headlight On/off: When the power is turned on, push the headlight switch up to turn on the headlights.

Turn Signal Light On/off: When the power is turned on, push the turn signal light switch to the left when you are about to make a left turn and push it to the right when you are about to make a right turn.

Switching between single-motor and Dual Motor

When the power is turned on, short-press the motor switch once to switch between single-motor mode and dual-motor mode.

 

Hidden Menu

When the power is switched on, press the function switch button 3 times in a row to enter the hidden menu setting interface.

In the hidden menu, short press the function switch button to switch among different pages, including P1, P2, P3, P4, P5, P6, P7, P8, PA, and Pb. To set the current page, long press the function switch button for 3 seconds, and then the value on this page will flash. Then short press the function switch button to set the value. After setting, long press the function switch button again to exit. It will exit automatically if there is no operation for 8 seconds.

 

P1: Switching between km and mile. The default unit is km.

P2: Setting the voltage level: 36V/48/52/60V/72V.

P5: Cruise control: 0 means the cruise mode is off, and 1 means the cruise mode is on.

P6: Switching between zero and non-zero start, 0 means zero start, and 1 means non-zero start. In non-zero start mode, you need to slide the scooter above 5km/h and then press the accelerator to start.

P7: Setting the speed limit between 0-100%;

P8: Setting the sleep time between 0 and 60 minutes; 0 means it never sleeps. The default sleep time is 5 minutes.

PA: Setting the start strength between 1 and 5; 1 is the minimum, and 5 is the maximum.

PB: Setting the brake strength from level 1 to level 5; 1 is for 20%, 2 for 35%, 3 for 50%, 4 for 70% and 5 for 100%.

 

Unlock the secrets of your Gallop’s LCD control panel and embark on a heart-pounding expedition. Unleash a powerful connection that propels you into a realm of thrills and spills, where the wind murmurs ancient tales and the horizon tantalizes with limitless potential. Brace yourself for an electrifying adventure like no other!